To Next PageTo Next PageHow to fix Tecsun PL-310 Receiver that won't turn on?
If your Tecsun Receiver won't turn on, the issue might be due to several reasons: the batteries may be out of power, they might not be installed correctly (check the '+' and '-' signs), or the power button could be locked. Try replacing the batteries with new ones or pressing the unlock button.
Why does my Tecsun Receiver keep turning off?
If your Tecsun Receiver turns off while you're listening, it could be due to low battery power or the sleep timer being activated. Try replacing the batteries or simply turning the radio on again.
How to fix Tecsun PL-310 not storing stations?
If your Tecsun Receiver can't store some stations or stores them with noise using ATS, the frequency of the stations might be too weak, or there could be interference nearby. Try searching for the station manually, lowering the antenna, or moving to another location and trying again.
What to do if Tecsun PL-310 alarm makes noise?
If your Tecsun Receiver alarm only produces noise, it could be due to several reasons: the radio station for the alarm may not be set correctly, there might be no broadcast on that station, or you may be in a location where the preset frequency isn't available. Try presetting your alarm station properly, ensuring there's a radio broadcast in your location, or setting the alarm by buzzer.
General| Frequency Range FM | 87-108 MHz |
|---|---|
| Frequency Range MW | 522 - 1620 kHz |
| Frequency Range SW | 1711 - 29999 kHz |
| Tuning Steps SW | 5 kHz |
| SSB | No |
| Type | Portable |
| Tuning Type | Digital |
| Frequency Range LW | 153-513 kHz |
| Tuning Steps MW | 9 kHz |
| FM Sensitivity | 3 uV |
| MW Sensitivity | ≤1 mV/m |
| Audio Output | 3.5 mm headphone jack |
| Output Power | 0.1 W |
| Speaker | Built-in |
| Additional Features | Alarm, Sleep Timer |
