Tecsun R-108 - DELETE MEMORY; Deleting a Single Memory Manually; Semi-Auto Delete Memory

www.tecsunradios.com.au
7
DELETE MEMORY (Refer to 11)
1. Select your desired band by pressing [BAND] button;
2. Press the [VM/VF] button to switch into frequency mode, switch
to address status;
3. Press & hold the [DELETE] button until “DEL” and “memory
address” flashing;
4. Rotate the [TUNING] knob to select the memory that you want to
delete;
5. Press the [DELETE] button to remove the unwanted
memory address.
AUTO BROWSE MEMORY (Refer to 11)
1. Select your desired band by pressing [BAND] button;
2. Press the [VM/VF] button to switch into frequency mode, switch to
address status, with memory address number flashing;
3. Press & hold / button, auto scan from one memory to
another, staying on each station for about 5 seconds.
4. To stop auto search memory, simply press the / button.
SQUELCH SETTING (Refer to 17)
1. Press the [POWER] button to turn on the radio and select your
desired band by pressing [BAND] button；
2. Press & hold [SQUELCH] button，Switch to the signal strength
selection page；
3. Rotate the [TUNING] knob to select signal strength；
4. Press the [SQUELCH] button again to confirm
SWITCH SOUND MODE (Refer to 16)
1.Turn on the radio and select any band you desired ；
2. Press & hold number“4”button，and then switch the sound mode
MUSIC/VOICE.
TUNING SPEED SETTING (Refer to 17 )
1. Turn on the radio and select any band you desired；
2. Press the [SQUELCH] button to select Fast/Slow speed or
select Stop to lock station.