Tecsun R-108 - How to Turn On;Off the Radio; Tune into Stations

www.tecsunradios.com.au
8
►HOW TO TURN ON/OFF THE RADIO
1. Open the battery compartment located on the back of the radio;
Install 1 x BL-5C battery. Close the battery door. The LCD display
shows the battery level, time and other symbols
2. Press the [POWER] button to turn on/off the radio.
Note: If the radio does not turn on, please check if the battery were
installed correctly, or the battery capacity is sufficient and the lock
function has not been turned on.
(Press & hold the [ ] button to unlock.)
►TUNE INTO STATIONS
Press the [POWER] button to turn on your radio, and then select your
desired band by pressing the [BAND] button. In case of receiving FM/ SW
broadcasting, fully extend the telescopic antenna for a better reception.
When receiving MW (LW) broadcasting, please rotate the radio or change
it's location to achieve optimum reception.
Rotate the [VOLUME] button to adjust the volume.
Now, you can turn into your favorite stations with any of the below
tuning methods:
METHOD 1: MANUAL TUNING
1. Press the [VM/VF] button to switch into frequency mode, and
hear a sound of “Be---” with “PRESET’’ flashing;
2. Rotate the [TUNING] knob to search your desired station.
METHOD 2: DIRECT KEYPAD ENTRY
1. Press the [FREQ] button, you can hear a sound of "Be---"；
2. Press the numeric keys [0] - [9] to enter the station frequency
directly
.