Tecsun R-108 - CLOCK SETTING; Set the Alarm Time

www.tecsunradios.com.au
9
Notes:
1. Ignore the decimal point for FM band when inputting
the frequency numbers.
For example, FM 89.3 MHz, just enter 8 9 3.
2. If the entered frequency is not within the covering area,
the display would display “Err” (error) symbol.
►WORKING WITH STATION MEMORIES
There are in total 500 memory presets within the unit. 100 memory
presets for each FM、MW、LW、SW 、AIR band.
METHOD 1: Auto Tuning Storage (ATS)
●FM ATS
1. Fully extend the telescopic antenna and press the [BAND]
button to select FM band;
2. Press & hold the [BAND] button until “PRESET” flashing and the
frequency is counting; now the unit starts scanning and storing
all available stations into the memories;
3. When the frequency stops counting, it means the ATS operation
is done completely. Now you can rotate the [TUNING] knob to
browse for those stored stations.
●MW/LW ATS
1. Press the [MW/LW] button to select MW/LW band;
2. Press & hold the [BAND] button until “PRESET” flashing and the
frequency counting; now the unit starts scanning and storing all
available MW/LW band stations into the memories；
3. When the frequency stops counting, it means the ATS operation
is done completely. Now you can rotate the [TUNING] knob to
browse for those stored stations.
●SW ATS
1. Fully extend the telescopic antenna and press the [BAND] button
to select SW band;