844-AB Sprayer control 29
Software 4.03
Printing
The printing feature is only available on 844-
AB consoles that have been upgraded with
the communications package. The 844-AB
communications package is available through
authorized TeeJet Technologies suppliers.
The printout generated by the 844-AB
contains information collected from 844-AB
memory. To ready the 844-AB for printing,
refer to Communications in System Setup
mode and select either “user prt ” or “cnt prt ”
depending on which report is desired. Exit the
mode by pressing and holding the Program
key for three seconds.
Connect a standard serial port printer to the
844-AB console and make sure that the
printer LED ’s are lit, indicating that the printer
has power. Ensure that the console is in
Operations mode and the Master Boom
Switch is set to “Off”. Press and hold the
Minus key for three seconds to begin printing.
To reset the values to zero, press and hold
the Plus and Minus keys simultaneously for
three seconds.
NOTE:
Printing is available only to those 844-AB
consoles that have been upgraded with the
COMMUNICATIONS PACKAGE. To
determine 844-AB console printing
capabilities, examine the left end plate of
the console. A communications-ready
console will have an RS-232 pin connector
attached to the left end plate. If the end
plate has no connector, the console has
not been upgraded and cannot print.
To Next Page
Loading...
