Teeter Sit-Stand Desk - Assemble Seat Support Frame to Seat Cushion; Assemble Seat Support Frame into Seat Frame Connector

STEP 8
Assemble Seat Support Frame into Seat Frame Connector
• Pull out the Seat Height Auto-Locking Knob with one hand while
inserting the Seat Support & Cushion into the Seat Frame Connector.
• Release the Auto-Locking Knob and continue to insert the Seat
Support Assembly until the red button on the Auto-Locking Knob
depresses or “locks” in a hole setting (Figure 9).
• Tighten the Auto-Locking Knob. Do not overtighten.
• See pg. 10 for instructions on how to adjust the stool height to your
preferred setting and how to properly secure the knob.
8
STEP 7
Assemble Seat Support Frame to the Seat Cushion
• Locate the Seat Cushion Assembly Hardware Kit (HK1033).
• Place the Seat Cushion on top of the Seat Support Frame and align
the holes. Insert the bolt through the designated hole and secure
with the washer and nut. Do not overtighten (Figure 8a).
• Insert the Seat Angle Adjustment pin through the Seat Support
Frame and Seat Cushion through one of the designated hole settings
(Figure 8b).
• See pg. 10 for instructions on how to adjust the angle of the
Seat Cushion.
FIGURE 8a
FIGURE 9
FIGURE 8b