Engineering Department
43 Beaver Brook Road
Danbury, CT 06810
(203) 791-1400 Phone
(203) 798-6534 Fax
VorTek
Installation Drawing
Revision Letter: A
Index No: 1-1
Revision Date: 12/11/96
Filename: T-VT5100A.CDR
Drawn By: GV
SENSOR ENCLOSURE AND
NOTES:
1. INSTALL IN ACCORDANCE WITH AIRFLOW DIRECTION
INDICATOR.
2. FOR QTY. OF PROBES & SENSORS PER PROBE
SEE SCHEDULE.
3. FOR SINGLE BAR UNITS USE PROBE ASS'Y 1 ONLY.
FOR UNITS WITH TWO BARS USE PROBE ASS'Y 1 & 2.
4. FOR DUCT DIAMETERS OF 14" OR LESS PROBE IS
CAPPED WITH NO STUDS OR NUTS PROVIDED.
IN THIS CASE, NO (5/16") HOLE SHOULD BE DRILLED.
SLOT IN ROD TO BE
ALIGNED WITH AIRFLOW
DIRECTION
SECTION A-A
PROBE ALIGNMENT SLOT
REQ'D FOR ALL BARS
DUCT CROSS SECTION
MOUNTING PLATE
PROBE BAR
PREFAB CABLE
SENSOR CLAMP
SHEDDER BAR
SHROUD
TO TRANSMITTER
TYPICAL SENSOR
(FOR QTY. OF SENSORS
PER PROBE SEE SCHEDULE).
PROBE ASS'Y 1
STRAIN RELIEF FITTING
PROBE ASS'Y 2
(IF APPLICABLE)
5/16" STUD
W/LOCK NUTS
(SEE NOTE 4)
A
A
DUCTWORK FOR
INSERTION OF PROBE
MOUNTING PLATE
CONNECTION CABLE
INSERTION SIDE
#10 TEK
SCREW (TYP.)
(INCLUDES INTEGRAL GASKET)
3 3/4" DIA. HOLE IN
6" X 6"
Airflow Measuring Probes
Circular Duct Insertion Probes
Selection of Materials For Construction
Aluminum
& ABS
CPVC
& ABS
304 St Steel High Temp.
St. Steel
To Next Page
Loading...
