Teka LFE 101 - User Manual

Questions and Answers

K
Kevin BriggsAug 11, 2025
Why is the suction power too low in my Teka LFE 101 Industrial Electrical system?
- J
  James HicksAug 11, 2025
  If the suction power of your Teka Industrial Electrical system is too low, and smoke is hardly extracted, several factors could be at play. First, the filter element might be saturated, requiring replacement and proper disposal of the old filter. Also, check if the filter elements are saturated because compressed air is not connected and connect it if needed. Damage to the extraction elements, a contracted suction or exhaust line, or throttle valves in the suction line could also be the cause. In these cases, replace the extraction elements or check and fix the contracted lines, or adjust throttle valves.
S
Shannon FryeAug 19, 2025
What to do if there is dust at the service door of the filter housing in Teka Industrial Electrical?
- D
  Donald MorganAug 19, 2025
  If you find dust at the service door of the filter housing of your Teka Industrial Electrical system, it could be due to several reasons. Ensure that the door is correctly closed. If the seal between the service door and filter housing is damaged, it must be replaced. Additionally, check if the compressed air for dedusting is set too high and reduce it if necessary. If dust is escaping at the hinge, the hinge may need to be reoriented or replaced.
T
Timothy CarrollAug 27, 2025
How to fix dust at the dust collecting tank in Teka LFE 101?
- F
  fcooperAug 27, 2025
  If you're experiencing dust at the dust collecting tank of your Teka Industrial Electrical system, it may be because the dust collection container is too full, so you should empty it. Another potential cause is that the clamping lever has not been lifted up, so lift it up. Also, the seal of the dust collecting tank might be damaged and needs replacement. Lastly, the compressed air for dedusting might be set too high; try reducing it.
J
Joseph CummingsSep 3, 2025
Why Teka LFE 101 Industrial Electrical system does not start?
- M
  Melissa KellySep 3, 2025
  If your Teka Industrial Electrical system does not start, there are a couple of things to check. First, ensure the plug power supply is correctly inserted; if it's missing or incorrectly inserted, check the plug connector and plug it in correctly. Also, verify that there is power at the outlet; if there is no power, check the mains and remove any errors if possible.