Why is the suction power too low on my Teka LFE 101 ST1?
The suction power might be low because the filter element is saturated, requiring you to replace the filter package and dispose of the old filter properly. Another cause could be that the filter elements are saturated because no compressed air is connected; in this case, connect compressed air.
What to do if there is dust at the service door of the Teka LFE 101 ST1 Industrial Electrical filter housing?
If you notice dust at the service door of the filter housing, it could be due to several reasons. First, ensure the door is correctly closed. If the seal between the service door and filter housing is damaged, it must be replaced. Additionally, check if the compressed air for dedusting is set too high and reduce it if necessary. Finally, if dust is escaping at the hinge, the hinge must be reoriented or replaced.
What to do if my Teka LFE 101 ST1 system does not start?
If your system isn't starting, check that the plug connector is correctly inserted into the power supply. If it is, verify that there is power at the outlet and address any issues with the mains if possible.
What to do if there is dust at the dust collecting tank of Teka LFE 101 ST1?
If you find dust at the dust collecting tank, it might be because the dust collection container is too full; empty it. Also, ensure the clamping lever is lifted up. If the seal of the dust collecting tank is damaged, it needs replacement. Finally, check if the compressed air for dedusting is set too high and reduce it if necessary.
General| Brand | Teka |
|---|---|
| Model | LFE 101 ST1 |
| Category | Industrial Electrical |
| Language | English |
To Next Page
