Table of contents
1. General 4
2. Description of the system elements 5
2.1. Illustration of the system elements 5
2.2. Functionality of the system 6
2.3. Intended use 6
2.4. Residual risk 6
3. Safety instructions 7
3.1. Definition of the hazard symbols 7
3.2. General safety instructions 7
4. Storage, transport and installation of the device 8
5. Commissioning 9
5.1. Connecting the suction line and exhaust air line 9
5.2. Electrical connection 10
5.3. Precoating of the filter cartridges 10
5.4. Connecting the compressed air supply 11
5.4.1. Compressed air supply for the cleaning of the filter cartridges 11
6. Operating the system 12
6.1. Explanation of the operating elements 12
6.2. Connection of an external control 13
7. Maintenance 14
7.1. Reset to maintenance state 15
7.2. Cleaning the filter cartridges 15
7.3. Replacing the filter cartridges 16
7.4. Emptying the dust collecting tank 18
7.5. Draining the condensate 20
7.6. Precoating of new filter cartridges 21
7.7. Replacing the particle filter 22
7.8. Replacing the activated carbon / the activated carbon cassette 24
7.8.1. Replacing the activated carbon 24
7.8.2. Replacing the activated carbon cassette 27
7.9. Replacing the cooling air filters of the turbines 28
7.10. Replacing the filter mats for the air outlet grille 28
7.11. Cleaning/replacing the particle sensor 29
7.12. Check/replace the dust filters for underpressure measurement lines 30
8. ATEX operation 31
8.1. ATEX zoning 31
8.2. Sources of ignition 33
8.2.1. Evaluating the risk of ignition in accordance with DIN EN 80079-36 33
9. Dismantling / Disposal 33
10. Diagnostics and troubleshooting 34
BA_LFE-101-201-301_ST1_20230808_EN
To Next Page
Loading...
