7.4. Emptying the dust collecting tank
The dust collection container must be cleaned after a certain number of operating hours. This range
depends on the amount of dust. The dust collecting tank may only be filled up to a maximum of 25%.
The filling level has to be proofed at least once a week.
Whirling up dust is possible due to the polluted filter cartridges! Danger of
unintentional automatic cleaning with the unit switched off.
The filter cartridges must be cleaned before emptying the dust collecting tank.This is done
by carrying out 3 manual cleanings via the unit control (see separate operating
instructions).The filter unit must be switched off beforehand but without disconnecting the
unit from the power supply.After the cleaning, disconnect the filter unit from the power supply
and secure it against being switched on again. After cleaning the filter cartridges wait about
5 minutes before opening the service door.
Explosion hazard!
During the discharge process, there must not be any effective
sources of ignition in the vicinity of the dust collecting container. The
maintenance personnel must ensure that static discharges are
avoided during work at the unit.
Explosion hazard!
No bags may be placed in the dust collecting container (risk of
build-up of static charges).
BA_LFE-101-201-301_ST1_20230808_EN
To Next Page
Loading...
