Do you have a question about the Teknetics Tek-Point and is the answer not in the manual?
Instructions for powering the device on and off.
Steps to customize alarm types and sensitivity settings.
Procedure to calibrate the pinpointer to specific soil conditions.
Steps for removing and installing batteries in the pinpointer.
Describes the audio alert for low battery levels.
Describes the alert and shutdown for critically low batteries.
Solutions for issues related to short battery life.
Solutions for when the pinpointer fails to power on.
Solutions for when the LED light flashes, indicating overload mode.
Solutions for unresponsive buttons or detection failures.
Solutions for false alarms or erratic beeping in the air.
Solutions for erratic beeping when touching the ground.
Solutions for interference issues between the pinpointer and metal detector.
| Type | Pinpointer |
|---|---|
| Operating Frequency | 12 kHz |
| Water Resistance | Yes |
| Sensitivity | Adjustable |
| Vibration | Yes |
| Audio Alerts | Yes |
| LED Light | Yes |
| Target ID | No |
| Length | 9 inches |
| Battery | 9V alkaline (included) |