Teknetics Tek-Point - Interference (Frequency Shifting)

헀
____________________________________
Interference (Frequency Shifting)
All metal detectors operate at different frequencies. It’s these
different frequencies that make certain detectors better at
detecting certain targets. The Tek-Point is designed to work with
the different frequencies of various detectors, and to enable the
user to calibrate the Tek-Point to a frequency that eliminates (or
minimizes) interference with your detector.
The factory default setting of the Tek-Point may interfere with your
metal detector, causing it or your pinpointer to beep irregularly.
A pinpointer is most
likely to interfere
with your metal
detector when
pointed into the
horizontal plane of
the searchcoil.
To minimize
interference while
probing the
ground, lay the
metal detector
down with the
searchcoil
perpendicular to
the ground.
OPERATION