___________________________________
헁
To shift Tek-Point operating frequency:
1. Turn off the Tek-Point.
2. Turn on your metal detector and set the sensitivity to a
level at which it is stable (no irregular beeping).
3. Quick-Press to turn Tek-Point power on. (Your metal
detector may start beeping).
4. Press-and-Hold the button.
Do not release the button at the first alarm (beep or vibrate).
Following the power-down-alarm, hear the
programming-alarm: TELEPHONE-RING.
Do not release the button at the programming alarm;
continue to hold the button.
5. Release the button when you hear the DOUBLE
TONE-ROLL.
The device is now in frequency-shift mode.
• Each time you press-and-release the button, you’ll
hear a short-beep.
• The short-beep means the frequency has changed.
• There are 16 different frequency settings.
• If you cycle through all 16 frequencies, you’ll hear a
double-beep. You can cycle through all of the frequency
selections again if you continue to press-and-release.
6. When you reach the desired frequency, your metal
detector will stop beeping. Stop pressing the button.
7. The pinpointer will alarm one final time after your
programming is complete.
8. Ready to hunt. The Tek-Point will retain this
programmed frequency setting.
OPERATION
INTERFERENCE (CONTINUED)
To Next Page
Loading...
