C
LEAR
P
ATH
-SC
U
SER
M
ANUAL
R
EV
.
1.36
43
T
EKNIC
,
I
NC
. T
EL
.
(585)
784-7454
C
LEAR
P
ATH
I/O
C
ONNECTOR
This connector sends communication and input signals from the SC Hub
to the ClearPath-SC motor. The required cable is a straight-through, 8-pin
to 8-pin Molex MiniFit Jr. cable (Teknic P/N: CPM-CABLE-CTRL-
MU120).
E
ND
-
OF
-
LOOP
H
EADERS
Place a jumper block on the 2-pin header associated with the last motor
connected to your SC Hub. For example. if you are connecting just one
motor to the SC Hub, place the jumper on J0. For two motors, place the
jumper on J1. If you plan to connect a second SC Hub (for systems with
five or more motors) place the jumper at J5, then on the second SC Hub
place a jumper on the appropriate header.
To Next Page
Loading...