Documentation
Review the following user documents before installing and using your instrument. These documents provide important operating
information.
Product documentation
The following table lists the primary product specific documentation available for your product. These and other user documents are
available for download from tek.com. Other information, such as demonstration guides, technical briefs, and application notes, can also be
found at tek.com.
Document Content
Installation and Safety Instructions Safety, compliance, and basic introductory information for hardware
products.
Help In-depth operating information for the product. Available from the
Help button in the product UI and as a downloadable PDF on
www.tek.com/downloads.
Quick Start User Manual Introduction to product hardware and software, installation
instructions, turn on, and basic operating information.
Specifications and Performance Verification Technical Reference Instrument specifications and performance verification instructions
for testing instrument performance.
Programmer Manual Commands for remotely controlling the instrument.
Declassification and Security Instructions Information about the location of memory in the instrument.
Instructions for declassifying and sanitizing the instrument.
Service Manual Replaceable parts list, theory of operations, and repair and replace
procedures for servicing an instrument.
How to find your product documentation
1. Go to tek.com.
2. Click Download in the green sidebar on the right side of the screen.
3. Select Manuals as the Download Type, enter your product model, and click Search.
4. View and download your product manuals. You can also click the Product Support Center and Learning Center links on the page for
more documentation.
Operating requirements
Use the instrument within the required operating temperature, power, altitude, and signal input voltage ranges to provide the most accurate
measurements and safe instrument operation.
Environment requirements
Characteristic Description
Operating temperature 0 °C to +50 °C (+32 °F to +122 °F). For proper cooling, keep the sides of the instrument clear of
obstructions for 2 inches (51 mm).
Operating humidity 5% to 90% relative humidity (% RH) up to +40 °C (+104 °F), non-condensing
5% to 55% RH above +40 °C up to +50 °C (+104 °F to +122 °F), non-condensing
Operating altitude Up to 3000 meters (9842 feet)
Preface
16
To Next Page
Loading...
Need help?
General
