Installation
2. Power off your oscilloscope.
3. Insert the USB fl ash drive into the front-panel
USB port o
n your oscilloscope.
4. Power on the oscilloscope. The oscilloscope
automatically recognizes and installs the
replacement fi rmware.
If the oscilloscope does not install the
firmware, rerun the procedure. If the
problem continues, try a different model of
USB flash drive. Finally, if needed, contact
qualified service personnel.
NOTE. Do not power off the oscilloscope or
remove the USB flash drive until the oscilloscope
finishes installing the firmware.
MSO2000B and DPO2000B Series Oscilloscopes User Manual 19
To Next Page
Loading...
