Maintenance
Unpacking and Repacking Instructions
This section contains the information needed to u npack the oscilloscope and
repack it for shipment or storage.
Unpacking
The oscilloscope and its standard accessories are carefully packed at the factory in
a s hipping carton. If, upon receipt, damage to the shipping carton is evident, tell
the shipper. Tektronix, Inc. is not responsible for damage caused during shipping.
If you have not already done so, carefully remove the oscilloscope and its
accessories from the shipping carton and inspect them for dam age. Save the
shipping carton for repacking or storage.
Repacking
Use a corrugated cardboard shipping carton having a test strength of at least 275
pounds (125 kg) and with an inside dimension at least six inches (15.25 cm)
greater than the instrument dimensions.
If the instrument is being shipped to a Tek t ron i x Service Cente r, enclose th e
following information:
The o wner’s address
Name and phone number of a contact person
Type and serial number of the instrument
Reas
on for returning
A complete description of the service required
Seal the shipping carton with an industrial stapler or strapping tape.
Mark the address of the Tektronix Service Center and also your ow n return address
on the shipping carton in two prominent locations. See www.tektronix.com/service
to find a service center near you.
S
torage
The oscilloscope should be stored in a clean, dry environm ent. The following
environmental c haracteristics apply for both shipping and storage:
Temperature range: –40 °F to +160 °F (–40 °C to +71 °C)
Altitude: To 39,370 feet (12,000 m )
See the Tektronix MDO3000 Series Mixed Domain Oscilloscopes Specifications
and Performance Verification Technical Reference for a complete listing of the
environmental specifications.
MDO3000 Series Mixed Domain O sc illoscopes Service Manual 19
To Next Page
Loading...
