Command Descriptions
TDS Family Oscilloscope Programmer Manual
2–143
% #$
!
#"
#"
$
% #
#" specifies that the delayed time base runs a user-specified amount of
delay time after the main trigger event.
#" specifies that the delayed time base is triggerable after the main time
base triggers.
returns either or , indicating the delayed time base mode.
HORizontal:DELay:SCAle
Sets the time per division for the delayed time base. This is equivalent to setting
Delayed Scale in the Horizontal Scale side menu.
On the TDS 4XXA, changes made while the external clock is enabled do not
take effect until the internal clock is enabled. Also, when the external clock is
enabled, the query form of this command returns an <NR3> value representing
‘50’.
Horizontal
HORizontal:DELay:SECdiv
% #$
% #$
$
% #
!
is the time per division. The range is 10 s (5 s on the TDS 620A, 640A,
and 644A and 20 s on the TDS 4XXA) to 500 ps (1 ns on the TDS 4XXA and
200 ps on the TDS 784A) in a 1–2–5 sequence. Values that are not in a 1–2–5
Arguments
Examples
Group
Related Commands
Syntax
Arguments
To Next Page
Loading...
