Command Descriptions
TDS Family Oscilloscope Programmer Manual
2–161
or = 0 turns off limit testing.
or 0 turns on limit testing.
specifies that limit testing of waveforms is in effect.
returns either or , indicating whether limit testing of waveforms is in effect.
LIMit:TEMPLate (No Query Form)
Creates a template which you can use for limit testing. You can compare the
waveform acquired through the specified channel against this template. The
template can be a waveform saved in any of the reference locations REF1
through REF4, or none.
Limit Test
LIMit:TEMPLate:DESTination, LIMit:TEMPLate:SOUrce, LIMit:TEM-
PLate:TOLerance
creates a template with the specified source waveform and tolerances, and
stores it in the destination reference waveform to be used in limit testing
comparisons.
creates a template with the specified source waveform and tolerances, and stores
it in the destination reference waveform to be used in limit testing comparisons.
Arguments
Examples
Group
Related Commands
Syntax
Arguments
Examples
To Next Page
Loading...
