Tektronix TDS 410A - Page 203

Command Descriptions
TDS Family Oscilloscope Programmer Manual
2–185
MEASUrement:MEAS<x>:STATE { OFF | ON | <NR1> }
MEASUrement:MEAS<x>:STATE?
ON
<NR1>
MEAS
:
:MEASUrement
STATE
<x>
<Space>
OFF
?
OFF or <NR1> = 0 turns measurements off. You can also turn the state off by
deselecting the source.
ON or <NR1>  0 turns measurements on.
MEASUREMENT:MEAS1:STATE ON
turns measurement defined as MEAS1 on.
MEASUREMENT:MEAS4:STATE?
returns either 0 or 1, indicating the state of MEAS4.
MEASUrement:MEAS<x>:TYPe
Sets or queries the measurement type for the measurement specified by
MEAS<x>. This is equivalent to selecting the measurement in the Select
Measurement side menu.
Measurement
MEASUrement:MEAS<x>:TYPe { AMPlitude | AREa | BURst | CARea |
CMEan | CRMs | DELay | FALL | FREQuency | HIGH | LOW | MAXimum |
MEAN | MINImum | NDUty | NOVershoot | NWIdth | PDUty | PERIod
|PHAse | PK2pk | POVershoot | PWIdth | RISe | RMS }
MEASUrement:MEAS<x>:TYPe?
Syntax
Arguments
Examples
Group
Syntax