Command Descriptions
TDS Family Oscilloscope Programmer Manual
2–207
The *RST command does not alter the following:
H The state of the IEEE Std 488.1–1987 interface.
H The selected IEEE Std 488.1–1987 address of the digitizing oscilloscope.
H Calibration data that affect device specifications.
H The Output Queue.
H The Service Request Enable Register setting.
H The Standard Event Status Enable Register setting.
H The Power-on status clear flag setting.
H Alias definitions.
H Stored settings.
H The *PUD? response.
RS232:BAUd
RS-232/Centronics Hardcopy Interface Only
Sets or queries RS-232-C interface transmission speed.
RS232
where can be 300, 600, 1200, 2400, 4800, 9600 or 19200.
sets the transmission rate to 9600 baud.
Group
Syntax
Arguments
Examples
To Next Page
Loading...
