Appendix A: Options and Accessories
Appendices
AĆ2
Warranty-Plus Service Options
The following options add to the services available with the standard warranty.
(The standard warranty appears following the title page in this manual.)
H
Option M2:
When Option M2 is ordered, Tektronix provides five years of
warranty/remedial service.
H
Option M3: When Option M3 is ordered, Tektronix provides five years of
warranty/remedial service and four oscilloscope calibrations.
H
Option M8: When Option M8 is ordered, Tektronix provides four calibra-
tions and four performance verifications, one of each in the second
through the fifth years of service.
Option 1F: File System (Standard on TDS 524A & TDS 544A)
With this option, Tektronix ships the digitizing oscilloscope with a floppy disk
drive and a variety of features for managing the floppy disk. With the file
system you can save and recall setups, waveforms, and hardcopies on a
floppy disk.
Option 1P: HC100 4 Pen Plotter
With this option, Tektronix ships a four-color plotter designed to make wave-
form plots directly from the digitizing oscilloscope without requiring an external
controller. It handles A4 and US letter size media.
Option 1Q/2Q: TDS Tutorial
With option 1Q (US) and 2Q (Europe), Tektronix ships a TDS tutorial.
Option 1R: Rackmounted Digitizing Oscilloscope
Tektronix ships the digitizing oscilloscope, when ordered with Option 1R,
configured for installation in a 19 inch wide instrument rack. Customers with
instruments not configured for rackmounting can order a rackmount kit
(016–1136–00 for field conversions).
Instructions for rackmounting the digitizing oscilloscope are shipped with the
option 1R.
Option 13: RS-232/Centronics Hardcopy Interface
(Standard on TDS 524A & TDS 544A)
With this option, Tektronix ships the oscilloscope equipped with a RS-232 and
a Centronics interface that can be used to obtain hardcopies of the oscillo-
scope screen.
To Next Page
Loading...
Need help?
General
