Command Descriptions
2–62
TDS Family Oscilloscope Programmer Manual
)("'!
"'*
&
("'!
%
#
$'*
$'* sets the channel bandwidth to 20 MHz.
& sets the channel bandwidth to 100 MHz (All TDS except 684A &
7XXA).
"'* sets the channel bandwidth to 250 MHz (TDS 684A & 7XXA only).
# sets the channel bandwidth to the full bandwidth of the digitizing oscillo-
scope.
sets the bandwidth of channel 2 to 20 MHz.
might return , which indicates that there is no bandwidth limiting on
channel 1.
CH<x>:COUPling
Sets or queries the input attenuator coupling setting of the specified channel.
This is equivalent to setting Coupling in the Vertical menu.
Vertical
CH<x>:IMPedance
)#"$ + , , -
)#"$
Arguments
Examples
Group
Related Commands
Syntax
To Next Page
Loading...
