Maintenance
TDS3000C Series S ervice Manual
4-7
You will need the following tools to remove and replace all the modules in the
oscilloscope.
H Torque-limiting screwdriver, 12 in/lb (1.3 Nā
m) range with TORX T-10 and
T-15 tips (If you are using a magnetic screwdriver with interchangeable bits,
the T-15 bit must be a long bit, at least 5 cm. (2 in) overall length).
H Screwdriver with
1
@
8
inch flat blade
H Needle-nose pliers
Tools Required
To Next Page
Loading...
