Tektronix TDS3034 Service Manual

Specifications
TDS3000 Series Service Manual
1–11
Table 1–1: Specifications (cont.)
Safety certifications and compliances
EC Declaration of
Conformity – Low
Voltage
Compliance was demonstrated to the following specification as listed in
the Official Journal of the European Communities:
Low Voltage Directive 73/23/EEC as ammended by 93/68/EEC
(TDS3000 Series
and P3010)
EN 61010-1/A2:1995
Safety requirements for electrical equipment for
measurement, control, and laboratory use
(P3010) EN 61010-2-031:1995
Particular requirements for hand-held probe assemblies
for electrical measurement and test equipment
(P6139A) HD401 S1
Safety requirements for electronic apparatus
Approvals
(TDS3000 Series
and P3010)
UL3111-1 – Standard for electrical measuring and test equipment
CAN/CSA C22.2 No. 1010.1 – Safety requirements for electrical
equipment for measurement, control and laboratory use
(P3010) EN 61010-2-031:1995 – Particular requirements for hand-held probe
assemblies for electrical measurement and test equipment
(P6139A) UL1244, Third Edition – Electronic measuring and test equipment
CAN/CSA C22.2 No. 231.1-M89 – Test probes
Installation Category
Descriptions
Terminals on this product may have different installation category
designations. The installation categories are:
CAT III Distribution-level mains (usually permanently
connected). Equipment at this level is typically in a
fixed industrial location
CAT II Local-level mains (wall sockets). Equipment at this
level includes appliances, portable tools, and similar
products. Equipment is usually cord-connected
CAT I Secondary (signal level) or battery operated circuits of
electronic equipment

Tektronix TDS3034 Specifications

General

Brand	Tektronix
Model	TDS3034
Category	Test Equipment
Language	English