TDS7104 & TDS7054 Service Manual
6-77
Repackaging Instructions
This section contains the information needed to repackage the oscilloscope for
shipment or storage.
Packaging
When repacking the oscilloscope for shipment, use the original packaging. If the
packaging is unavailable or unfit for use, contact your local Tektronix representa-
tive to obtain new packaging.
Seal the s hipping carton with an industrial stapler or strapping tape.
Shipping to the Service Center
Contact the Service Center to get an RMA (return material authorization)
number, and any return or shipping information you may need.
If the oscilloscope is being shipped to a Tektronix Service Center, enclose the
following information:
H The RMA number.
H The owner’s address.
H Name and phone number of a contact person.
H Type and serial number of the oscilloscope.
H Reason for returning.
H A complete description of the service required.
Mark the address of the Tektronix Service Center and the return address on the
shipping carton in two prominent locations.
To Next Page
Loading...
