12 13
Additional Users
Up to four additional users can be added. Additional users can;
turn the socket power (output) on or off and receive the power
loss/restore and temperature alerts.
Other Users
Any users who have not been programmed into this device have
no authorisation to control Powertxt®.
2.3. Setting the Master User
The first user to send the first SMS command to Powertxt® will
become the master user.
We advise you set the Powertxt® SIM mobile number up as a
contact in your phone so you can easily send text messages
(SMS commands) to it.
Please send the following SMS command to add a master user:
#00#
The GSM LED Light will flash rapidly when the device is sending
/ receiving an SMS (see point 1.5.)
2.4. Changing the Password
The password is automatically set at 1234 by default. We
recommend you change this password immediately, please keep
this password safe.
Please send the following command to change the password:
#04#OldPassword#NewPassword#
e.g. #04#1234#5678#
2.5. Setting the Time/Date
Note – If Powertxt® is being used for the first time or it has been
reset, the master user needs to set the time/date with this
command. The time/date is set according to the SMS centre
(the mobile network operator). If the time/date is not set the
device may use the original pre-set start date 00:00:00 1st June
2004.
Please send the following SMS command to set the time: #152#
(Note the reply format is YYYY/MM/DD)
2.6. Controlling the Power (Output) by SMS (e.g. Turning Your
Connected Equipment ON/OFF)
Master User
Send the following command to turn the power (output) ON:
#01#
Send the following command to turn the power (output) OFF:
#02#
Additional User
Send the following command to turn the power (output) ON:
#01#Password#
To Next Page