14 15
e.g. #01#1234#
Send the following command to turn the power (output) OFF:
#02#Password#
e.g. #02#1234#
2.7. Controlling the Power (Output) Manually
Press the Power Button (see figure 1) on the side of Powertxt®
for 1 second until the power (output) light goes off/on and then
again to turn power (output) back on/off.
2.8. Power Loss/Restore SMS Alerts
External Power Supply Lost
If Powertxt® is disconnected from external AC power or a loss of
the AC power occurs all functions of the socket are deactivated
including the Power Control button. Powertxt® will notify the
master user and any additional users ‘Mains Power Lost’
together with a temperature reading (if applicable). If the power
supply is lost and restored within 5 seconds a power loss SMS
may not be generated. The power loss/ restore alerts go to all
programmed users.
External Power Supply Restored
If Powertxt® is reconnected with external AC power or the
external AC power is restored all functions of the socket are
reactivated. Powertxt® will notify the master user and any
additional users ‘Mains Power Restored’ together with a
temperature reading (if applicable). When the external power
supply is resumed the output of Powertxt® will remain in the
same state as before power was disconnected. For example, if
the equipment connected to Powertxt® was ‘ON’ before the
external power supply was cut off the equipment will turn back
‘ON’ when power is restored.
Defining the Users
3.1. Changing the Master User
To change the master user’s number please send the following
SMS command: #14#NewMasterNumber#
e.g. #14#07590111222#
Note – When you have sent the command you will not receive a
reply as the master number has now changed. The new master
number will receive an SMS.
Warning - Please use this function carefully as once the master
user’s number has been changed the original user has no
authority within Powertxt®.
3.2. Adding an Additional User
Up to 4 additional users (family numbers) can be programmed
into Powertxt® to control it and receive SMS alerts. For
additional user information & command formats see point 2.2.
To add one additional user please send the following SMS
command: #06#AdditionalNumber#
e.g. #06#07866123456#
To Next Page