16 17
To add several additional users at the same time please send the
following SMS command:
#06#AdditionalNumber#AdditionalNumber#
e.g. #06#07866123456#07866222333#
(up to 4 additional users can be added within this command)
3.3. Deleting an Additional User
To delete an additional user please send the following SMS
command: #113#AdditionalNumber#
e.g. #113#07866123456#
To delete several additional users at the same time please send
the following SMS command:
#113#AdditionalNumber#AdditionalNumber#
e.g. #113#07866123456#07866222333#
To delete all additional numbers please send the following SMS
command: #113#
Controlling the Power (Output) by Time/Day & Delay
4.1. Setting the Time/Day Parameters
When the time/day has been set successfully the scheduled
parameters will be saved in Powertxt®. These settings are
saved in Powertxt® and will remain until the socket is reset to its
factory settings or the settings are changed by this method
again. If Powertxt® loses external power or is turned off these
parameters are still saved.
These parameters have to be set first then the function needs to
be turned ON/OFF with a second SMS Command (see points
4.2. & 4.3.).
Please send the following SMS command to set the time/day
control parameters: #129#WorkDay#StartTime#EndTime#
‘WorkDay’ This value lies in the range of ‘0’ to ‘9’, the following
table contains the descriptions of each value.
The ‘StartTime’ and ‘EndTime’ consists of 4 digits (hh:mm) and
works on a 24 hour clock, the ‘StartTime’ and ‘EndTime’ should
be in the same day and the ‘EndTime’ must be later than the
‘StartTime’ during the period.
The power (output) will switch ON at the ‘StartTime’ and switch
OFF at the ‘EndTime’.
eg. #129#5#0730#2130# . Powertxt® will switch power ON at
7.30am and switch power OFF at 9.30pm every Friday.
Value Corresponding Value Corresponding Value Corresponding
Day Day Day
0 Everyday 4 Thursday 8 Monday - Friday
1 Monday 5 Friday 9 Saturday - Sunday
2 Tuesday 6 Saturday
3 Wednesday 7 Sunday
To Next Page