- 5 -
GB
SPLITSPLIT
SPLITSPLIT
SPLIT 7000
1.3 General information
Every SPLIT LINE air conditioner consists of two
separate units:
1) CONDENSER UNIT which can be installed
outside the vehicle, inside the double floor, inside
the garage or a bench or a cabinet. The purpose
of this unit is to drive out hot air.
2) EVAPORATOR UNIT (or AERATOR) which
must be installed on the roof of the vehicle in
the place of a rooflight (40 x 40 cm) or else on
an aperture of the same size made in an area
of your choice on the roof itself. It has the
purpose of cooling the air inside the vehicle.
Both units are connected to each other by two very
thin hoses (6 and 10 mm). The hoses are
connected to the units by quick coupling joints
(which do not require any special tool).
All the SPLIT 7000 conditioners have been designed
to be fed using 230 VAC 50 Hz current.
The feeding voltage must fall
within the range of 205 VAC and 250 VAC, the
steady frequency between 49 Hz and 51 Hz.
Using the machine with other voltages or frequencies
will be harmful to proper operation of the air
conditioner, and will invalidate the warranty.
To Next Page
Loading...
