- 13 -
GB
SPLITSPLIT
SPLITSPLIT
SPLIT 7000
4.4 How to fasten the condenser unit
The condenser unit may be installed either
suspended on two brackets (not provided) on the
outside of the vehicle Fig. 9 Ref. (1), or resting on
the floor on the inside Fig. 9 Ref. (2).
Every conditioner comes provided with 4 L-shaped
brackets and 4 silent-blocks Fig. 9 Ref. (3).
In order to avoid transmitting any vibrations from
the condenser unit to the floor, it is important to fasten
the unit onto the silent-blocks.
NOTE: The condensing unit may be installed in the
horizontal position Fig. 9 Ref. (2) but NOT in the
vertical position.
9
43
1
2
Always close the condensing
unit
completely before starting the air
conditioner. If the conditioner is run with one
of the condensing unit lids open, the gas
pressure inside the pipes will continue to rise
and the 6 mm pipe will eventually burst.
Any breakages caused by failure to observe
this simple rule shall not be covered by the
warranty.
To Next Page
Loading...
