Teleco TVLink RS868 - User Manual

1
L
N
Open
Close
Com
Power
supply
240V
Motor
Courtesy
lamp
Ground
+ 12V
Com neg tx FTC
FTC
TD
Com
TB
Com
TD
TBRéflex photocell
Zone 240V
Safety zone, isolated low voltage
Motor
Motor Earth Mains Earth
Mains Live Mains Neutral
DateCode Number: Series Model number Draft
TVLink RS868
25/11/13
TVPRP868F08E
1- GENERAL DESCRIPTION
Electronic for the remote control of tubular motors for roller blinds, rolling shutters, doors with limit
switch inside or outside the motor, radio receiver section with transmitter channel memorization by
means of internal push button or via radio.
Possibility to connect wired with auto-test control before every closing movement.
Possibility to connect a 240 V
courtesy lamp with variable time from 1 min. to 12 hours (default
1min.)
Plastic housing for external use equipped with clamps.
Possibility of centralized controls for simultaneous control of several appliances.
Possibility to connect external mechanical controls with dynamic push button function and blockage
push button.
2- CONNECTIONS
Description of the connections:
1 Input ground general power supply
2 Input ground motor
3 Input general power supply 240 V
phase
4 Input general power supply 240 V neutral
5 Opening output relay motor contact
6 Output 240 V neutral by means of fuse
(common motor)
7 Closing output relay motor contact
10-11 Output LC 240 V 300 W max. for
courtesy lamp
(only for the version with courtesy light)
12 Positive output 12/15Vdc 80mA
for photocells
13 Safety common contact
14 Negative output for photocells (autotest)
15 FTC input (NC normally closed)
19 Push buttons common for TD
20 Dynamic push-button input (NO normally open)
21 Stop push-button TB (NC normally closed)
22 Push buttons common for TB
24 Antenna ground
25 Antenna pole (wire 8.5cm)
T574.01
TELECO AUTOMATION SRL - Via dell’Artigianato, 16 - 31014 Colle Umberto (TV) ITALY
TELEPHONE: ++39.0438.388511 FAX: ++39.0438.388536
www.telecoautomation.com
This document is the property of Teleco Automation Srl who reserves all reproduction and copying rights

Summary

General Description of the Control Unit

Control Unit Connections

Technical Specifications and Antenna

Dip-switch Configuration

Transmitter Memorization

Transmitter Memorization Methods

Details three methods for memorizing transmitters: single channels, two channels, or courtesy light.

Mode 1: Single Push-Button

Explains memorizing channels individually for dynamic open, stop, close control.

Transmitter Memorization Modes and Deletion

Mode 2: Channel Pairing

Describes memorizing channels in pairs for specific control functions.

Mode 3: Courtesy Light Control

Details memorizing channels for single on/off control of the courtesy light.

Cancelling Transmitter Codes

Procedure for cancelling single or paired transmitter codes from the receiver.

Cancelling All Memorized Codes

Instructions on how to erase all stored transmitter codes from the receiver.

Remote Code Cancellation

Method to cancel a specific code remotely using an existing transmitter.

Initial Radio Transmitter Insertion

Procedure for radio insertion of a master transmitter on an empty memory.

Memorizing Additional Transmitters

Guide to memorizing additional transmitter channels, single or in pairs.

Time Settings

Courtesy Light Time Setting

Steps to set the courtesy light duration from 1 minute to 12 hours.

Automatic Re-closing Time Setting

Procedure for setting the automatic re-closing time between 5s and 90s.

Courtesy Light Operation Modes

Courtesy Light as Alarm

Configuring the courtesy light output to interface with an alarm system.

Control Unit Signals and Safety Functions

Acoustic Signals

Explanation of various beep codes indicating unit status or errors.

Safety Inputs

Details on safety inputs like TB stop and photocells, and their functions.

Important Safety and Installation Warnings

Teleco TVLink RS868 Specifications

General

Brand	Teleco
Model	TVLink RS868
Category	Remote Control
Language	English