Telecrane F24+ Series User Manual

11
2. Pick up the e-Card from transmitter or receiver, and insert into the slot at the side of USB cable.
3. COM Port Selection: Select a COM port which USB cable is connected
4. Read e-Card Setting:
5. Writing to e-Card:
Make sure the e-Card has been inserting into the slot of USB interface cable.
 Click “Write Setting”
 Click “Finish” completing the writing
Note：Do not remove or disconnect the USB cable during reading or writing.

Telecrane F24+ Series Specifications

General

Brand	Telecrane
Model	F24+ Series
Category	Remote Control
Language	English