To Next PageTo Next PageWhat to do if a new Teledyne Analytical Instruments sensor responds slowly or drifts?
If a new Teledyne Analytical Instruments sensor responds slowly or drifts after being removed from its sealed bag, this might be because it needs time to stabilize. The solution is to wait for 1–2 hours and then recalibrate the sensor.
Guides on inspecting the unit, installing batteries, and connecting the sensor for operation.
Instructions for installing or replacing the R17MED oxygen sensor, including safety precautions.
Step-by-step guide for installing 3 AA alkaline batteries, including polarity and recalibration needs.
Explains the necessity and procedure for calibrating the AX300-I analyzer before use.
Covers pre-use checks, calibration, and basic operating modes for the analyzer.
Covers pre-use checks, calibration, and basic operating modes for the analyzer.
Provides a list of recommended actions (DOs) and prohibited actions (DON'Ts) for using the analyzer.
Emphasizes proper calibration before use, every 8 hours, or after battery/sensor changes.
Explains how the unit indicates faults (√SENSOR, alarms) and refers to troubleshooting table.
Describes the watchdog circuit that monitors electronics and displays error codes on the LCD.
Lists technical specifications including range, accuracy, response time, battery life, dimensions, and operating conditions.
Guides on inspecting the unit, installing batteries, and connecting the sensor for operation.
Instructions for installing or replacing the R17MED oxygen sensor, including safety precautions.
Step-by-step guide for installing 3 AA alkaline batteries, including polarity and recalibration needs.
Explains the necessity and procedure for calibrating the AX300-I analyzer before use.
Covers pre-use checks, calibration, and basic operating modes for the analyzer.
Covers pre-use checks, calibration, and basic operating modes for the analyzer.
Provides a list of recommended actions (DOs) and prohibited actions (DON'Ts) for using the analyzer.
Emphasizes proper calibration before use, every 8 hours, or after battery/sensor changes.
Explains how the unit indicates faults (√SENSOR, alarms) and refers to troubleshooting table.
Describes the watchdog circuit that monitors electronics and displays error codes on the LCD.
Lists technical specifications including range, accuracy, response time, battery life, dimensions, and operating conditions.
General| Brand | Teledyne |
|---|---|
| Model | AX300-I |
| Category | Analytical Instruments |
| Language | English |
