Telematrix 9600IP - Introduction to the 9600 IP Phone; Overview of Hardware; Overview of Software

5
1. Introduction
This is the user manual of 9600IP. Some configuration should be done before
use the 9600IP phone, then it can work normally. This manual will illustrate how to
set the phone through keyboard and web service.
1.1 Overview of Hardware
1.1.1
The two RJ-45 network interface support the 10/100M Ethernet. The default WAN
interface is a DHCP Client server. User connect the WAN interface to ADSL or
switch,
Lan is web-bridge mode, and bridged the LAN and WAN into the same network.
.
You can use the administrator’s user name “admin” and password“admin”to login
and set.
1.1.2
Only the WAN interface support the POE.
1.2 Overview of Software
Network Protocol Tone
 Ring Tone
 Ring Back Tone
 Dial Tone
 Busy Tone
Phone Function
 SIP v1(RFC2543)
V2(RFC3261)
 IP/TCP/UDP/RTP/RTCP
 IP/ICMP/ARP/RARP/SNTP
 TFTP Client/DHCP Client/PPPOE
Client
 Telnet/HTTP Server
 DNS Clients
Codec
 Volume Adjustment
 Speed dial key
 Phonebook
IP Assignment
 G.711： 64K bit/s(PCM)
 G.723.1： 63k/5.3k bit/s
 G.726
：
16k/24k/32k/40k
bit/s(ADPCM)
 G.729A
：
8k bit/s(CS-ACELP)
 G.729B
：
adds VAD & CNG to
G.729
 IP (Static IP)
 DHCP
 PPPoE
Voice Quality Security
 HTTP 1.1 basic/digest
authentication for Web setup
 MD5 for SIP authentication
(RFC2069/RFC2617)
QoS
 VAD： Voice activity detection
 CNG： Comfortable noise
generator
 LEC： Line echo canceller
 Packet Loss Compensation
 Adaptive Jitter Buffer
 QoS field
Call Function NAT Traversal
 STUN  Call Hold
 Call Waiting
Configuration