Why are the RTS, CTS, and TxD LEDs not blinking on my Telenetics Modem?
If the RTS, CTS, and TxD LEDs on your Telenetics Modem aren't blinking, it could be that the connected terminal or DTE isn't sending data. First, ensure data is actually being transmitted. If it is, check that the RS-232 cable is working properly and is securely connected to both the modem and the terminal or DTE.
Configuration options for DIP Switch SW1, including transmit level and dynamic range.
Configuration options for DIP Switch SW2, covering FSK modes and delays.
Configuration options for DIP Switch SW3, including data rate and operation modes.
Offers solutions for common modem operational problems and troubleshooting suggestions.
General| Device Type | Modem |
|---|---|
| Model | Flash Poll DSP 9612 |
| Manufacturer | Telenetics |
| Data Rate | 9600 bps |
| Interface | RS-232 |
| Error Correction | V.42 |
| Data Compression | V.42bis |
| Duplex | Full Duplex |
| Operating Modes | Synchronous, Asynchronous |
| Power Supply | External |
To Next Page
