Teletek electronics iRIS8 - Page 31

iRIS8 - Addressable Fire Alarm Panel – User & Maintenance Manual
31
Earth Fault function DISABLED
The Earth Fault indication is disabled.
Sounder Disabled
The Sounders are disabled.
Fire Brigade Output Disabled
The fire output is disabled.
Fire Protection Output Disabled
The extinguishing output is disabled.
Fault Output Disabled
The fault output is disabled.
Zone In Test
The zone is in test mode.
Transmitting device active
The Fire output is activated.
Extinguishing output active
The Extinguishing output is activated.
Sirens active
The sounders are activated.
User log off
Exit from access level 2 (Maintenance).
Installer log off
Exit from access level 3 (Installer).
User log on
Entry in access level 2 (Maintenance).
Installer log on
Entry in access level 3 (Installer).
High Resistance Disabled
The indication for high battery resistance is disabled.
Total loss of Power
Both main and backup power supply are lost (the main power supply is lost and
the accumulator battery is fully discharged).
Buzzer Disabled
The internal buzzer is disabled.
Network Fault
Redundant network breakdown.
Loop Device Disabled
The loop device is disabled.
Chamber Fault
Fault in the detector.
Clean Me Now
Dirty detector chamber.
Loop Device Input Fault
Fault in loop device input.
Loop Device Output Fault
Fault in loop device output.
Alarm
Fire alarm signal from detector.
PreAlarm
Fire alarm signal from detector in 2DEVICES or DOUBLE operation mode for
zone.
Test Alarm
Fire alarm signal from tested detector.
Loop Device Type Error
A different than the expected type of device has been detected at the address.
Loop Device Fault
The device does not respond (lost or damaged).
Double Address
More than one device with the same address in the loop.
Evacuate
Activated Call Point or EVACUATE button on the panel.
Log Fault
The Log file event is lost or damaged.
Gas Alarm
Activated gas detector SensoIRIS GAS.
Power Supply Fault
Fault in the external power supply of conventional zone module SensoIRIS MC-Z
or gas detector SensoIRIS GAS.
Panic
Panic alarm signal from detector.
Active Relay
Activated relay output of the panel. After the message is displayed also the
number of the activated relay (1-4).
Loop Device Input Active
Activated input of a loop device.
Loop Device Output Active
Activated output of a loop device.
Activated Output
Activated output of the panel.
Redundant processor fault
Redundant processor is failed.
Type Error
SensoIRIS MIO22M module. Wrong type of the output is detected. That means
that a jumper is set or removed when the power supply of the module is ON. The
fault will be cleared with switching off the power supply of the module, including
the external power supply unit, and switching it on again.
External Power Supply Fault
SensoIRIS MIO22M module. Missing or low external power supply. The fault is
cleared when the normal power supply is restored.