INSTRUMENT MANUAL
VACUUM GAUGE MODEL MM200
160Phone:(215) 947-2500 fax:(215) 947-7464 e-mail:sales@televac.com web site:www.televac.com
MM-200_im REV M
Page 107 of 160
R2AC<cr> 0-10V of 2As to be MP2C traditional.
R2AL<cr> 0-10V of 2As to be logarithmic.
R2AN<cr> 0-10V of 2As to be linear to (1) Torr.
R2AT<cr> 0-10V of 2As to be 2A traditional.
R3DL<cr> 0-10V of 3D to be logarithmic.
R3DM<cr> 0-10V of 3D to be multi linear.
R4AL<cr> 0-10V of 4As to be logarithmic.
R4AN<cr> 0-10V of 4As to be standard.
R7BE<cr> 0-10V of 7Bs to be extended log.
R7BL<cr> 0-10V of 7Bs to be logarithmic.
R7BM<cr> 0-10V of 7Bs to be multi linear.
R7BN<cr> 0-10V of 7bs to be linear.
R7EL<cr> 0-10V of 7Es to be logarithmic.
R7EM<cr> 0-10V of 7Es to be multi-linear.
SET POINTS
PCA<cr> Control all relays via RS232.
PCn<cr> Control relay "n" via RS232.
PFn<cr> Turn off controlled relay "n" via RS232.
PNn<cr> Turn on controlled relay "n" via RS232.
PUA<cr> Remove all relays from RS232 control.
PUn Remove relay "n" from RS232 control.
SAxSy Assign relay x to station y.
SPx<cr> Send the station assignment of relay x.
SPxN<cr> Send the "ON" setting of relay x.
SPxF<cr> Send the "OFF" setting of relay x.
SSxFyyyyu<cr> Set relay #x "OFF" to yyyy, units H or L.
SSxNyyyyu<cr> Set relay #x "ON" to yyyy, units H or L.
To Next Page
Loading...