Telit Wireless Solutions LN940A9 SERIES User Manual

80591ST10886A Rev.2 Page 118 of 200 2018-07-02
AT+CMGC=28
>
0891683108705505F011640B818175468071F20000A70FF4F2
9C0E1ABBDB6110BD3CA7D700
+CMGC: 51
OK
12.15. AT+CMMS More Messages to Send
Set command controls the continuity of SMS relay protocol link. When feature is enabled (and supportedby
network) multiple messages can be sent much faster as link is kept open.
Test command returns supported values as a compound value.
Syntax
Type
Command
Possible Return Result
Instruction
Test Command AT+CMMS=? <n>
Read Command AT+CMGC? OK -
Write Command AT+CMMS=<n> OK
Parameter Description
parameter
Value
Instruction
<n> 0 Disable
1 Keep enabled until the time between the response of the
latest message send command (+CMGS,+CMSS, etc.) and
the next send command exceeds 1-5 seconds (the exact
value is up to Meimplementation), then ME shall close the
link and TA switches <n> automatically back to 0
2
Enable (if the time between the response of the latest
message send command and the nextsendcommand
exceeds 1-5 seconds (the exact value is up to ME
implementation), ME shall close the linkbut TA shall not
switch automatically back to <n>=0)

Telit Wireless Solutions LN940A9 SERIES Specifications

General

Brand	Telit Wireless Solutions
Model	LN940A9 SERIES
Category	Control Unit
Language	English