Telit Wireless Solutions LN940A9 SERIES User Manual

80591ST10886A Rev.2 Page 61 of 200 2018-07-02
The execute command returns the list of operator names from the MT.
Syntax
Type
Command
Possible Return Result
Instruction
Execute
Command
AT+COPN -
OK
-
Test Command AT+ COPN=? OK -
8.7. AT+CPLS Selection of Preferred PLMN List
This command is used to select one PLMN selector with Access Technology list in the SIM card or
active application in the UICC (GSM or USIM), that is used by +CPOL command.
Syntax
Type
Command
Possible Return Result
Instruction
Read Command AT+ CPLS? +CPLS: 0
OK
-
Test Command AT+ CPLS =? +CPLS: 0,1,2
OK
-
Write Command AT+CPLS=<list> OK -
Parameter Description
parameter
Value
Instruction
<list> 0 User controlled PLMN selector with Access Technology EFPLMNwAcT,if not found in
the SIM/UICC then PLMN preferred list EFPLMNsel (this file is only available in SIM
card or GSM application selected in UICC)
1 Operator controlled PLMN selector with Access Technology EFOPLMNwAcT
2 HPLMN selector with Access Technology EFHPLMNwAcT

Telit Wireless Solutions LN940A9 SERIES Specifications

General

Brand	Telit Wireless Solutions
Model	LN940A9 SERIES
Category	Control Unit
Language	English