80591ST10886A Rev.2 Page 119 of 200 2018-07-02
12.16.
AT+CSAS Save Settings
Execution command saves active message service settings to a non-volatile memory. A TA can contain
several profiles of settings. Settings specified in commands Service Centre Address +CSCA, Set Message
Parameters +CSMP and Select Cell Broadcast Message Types +CSCB (if implemented) are saved. Certain
settings may not be supported by the storage (e.g. SIM SMS parameters) and therefore can not besaved.
Test command shall display the supported profile numbers for reading and writing of settings.
Syntax
Test Command AT+CSAS=? +CSAS: 0
OK
-
Write Command AT+CSAS=[<profile>] OK
Parameter Description
<profile> 0
0…255 manufacturer specific profile number where settings
are to be stored. Currently only one profile (0) is supported
12.17.
AT+CRES Restore Settings
Execution command restores message service settings from non-volatile memory to active memory. A TA can
contain several profiles of settings. Settings specified in commands Service Centre Address +CSCA, Set
Message Parameters +CSMP and Select Cell Broadcast Message Types +CSCB (if implemented) are restored.
Certain settings may not be supported by the storage (e.g. SIM SMS parameters) and there for ecan not be
restored.
Syntax