80591ST10886A Rev.2 Page 73 of 200 2018-07-02
<cid> 1-24
(PDP Context Identifier) A numeric parameter which specifies a particular PDP
context definition. The parameter is local to the TE-MT interface and is used in other
PDP context-related commands. The range of permitted values (minimum value = 1)
is returned by the test form of the command
<PDP_type> String type
“IP”,”IPV6”,”IPV4V6”,”PPP”
<APN> String type
(Access Point Name) a string parameter which is a logical name that is used to select
the GGSN or the external packet data network. If the value is null or omitted, then the
subscription value will be requested.
<PDP_addr> String type
A string parameter that identifies the MT in the address space applicable to the PDP.
If the value is null or omitted, then a value may be provided by the TE during the PDP
startup procedure or, failing that, a dynamic address will be requested. The read form
of the command will continue to return thenull string even if an address has been
allocated during the PDP startup procedure. The allocated address may be read using
the +CGPADDR command
<d_comp>
A numeric parameter that controls PDP data compression (applicable for SNDCP
only) (refer 3GPP TS 44.065 [61])
0
off(default if value is omitted)
1
on (manufacturer preferred compression)
2
V.42bis
<h_comp>
A numeric parameter that controls PDP header compression (refer 3GPP TS 44.065
[61] and 3GPP TS 25.323 [62])
0 off (default if value is omitted)
1 on (manufacturer preferred compression)
2 RFC1144 (applicable for SNDCP only)
3 RFC2507
4 RFC3095 (applicable for PDCP only)
Example
AT+CGDCONT=2,”IP”
OK
To Next Page
Loading...
Need help?
General
