Telkonet Ecosmart EcoInsight - Page 18

EcoInsight I, O & M Guide Telkonet, Inc.
For Use with Firmware Version 2.x 20800 Swenson Drive, Suite 175
Low Voltage Installation Waukesha, WI 53186
Revision 4.2 (414) 302-2299
Page 17 www.telkonet.com
Step 23 Determine which end of the adapter should be situated on top, and which end should be
situated on the bottom. As shown in Figure 16, the notch in the main display should be in
the upper left corner, and the smaller, vertical rectangle should be in the lower right
corner.
Figure 16: Determine Top & Bottom of Plate
Step 24 Mount the Telkonet JBOX adapter plate to the mud ring with two #6-32 1” screws. See
Figure 17.
Figure 17: JBox, Mud Ring & Adapter Plate
Step 25 Mount SS6000 backplate on top of JBOX adapter plate, using four #5 ½” coarse thread
screws. See Figure 18.