Telkonet Ecosmart EcoInsight - JBOX Using Vertical Mud Ring Instructions

EcoInsight I, O & M Guide Telkonet, Inc.
For Use with Firmware Version 2.x 20800 Swenson Drive, Suite 175
Low Voltage Installation Waukesha, WI 53186
Revision 4.2 (414) 302-2299
Page 16 www.telkonet.com
Figure 14: Drywall Mount Wiring
Step 15 Starting at the bottom of the terminal block and working up, use a precision screwdriver
to secure each of the wires into the appropriate pins on the terminal block. Low voltage
only: Using 20-18 gauge wire, leave a minimum of 8” of spare wire exposed from the wall
for connection directly to the thermostat’s back plate screw terminals.
Step 16 Low voltage only: Ensure backplate has appropriate jumpers between R, SW1 and SW2
assuming they are controlling all fan and modes from the same voltage as powering the
thermostat. If installing on a heat pump, ensure there is a jumper between Y1 and W1.
See Figure 15.
Figure 15: Backplate with Appropriate Jumpers
Step 17 Verify each wire is secure by gently tugging on it.
Step 18 Continue to Step 41.
JBOX Using Vertical Mud Ring Instructions
 Requires Telkonet JBOX Adapter Plate and two #6-32 1” screws
Step 19 Strip the LINE wire back 0.25 inches.
Step 20 Cap the LINE wire with a wire nut or electrical tape.
Step 21 Cut the COMMON wire so the copper is flush with the insulation.
Step 22 Strip all wires except for COMMON back 0.25 inches.