Telkonet ecosmart EcoTouch+ - Page 18

Test Lutron Lighting Scenes (if applicable)
EcoTouch+ IO&M Guide Telkonet, Inc.
For Use with Firmware Version 2.x 20800 Swenson Drive, Suite 175
Test Lutron Lighting Scenes (if applicable) Waukesha, WI 53186
Revision 5 (414) 302-2299
Page 15 www.telkonet.com
5) A “scene” will appear on the screen as shown here. (In this
example, it’s Unsold.) Touch Send.
9) If a Scene Fails
• Ensure the cable
connecting the Lutron
repeater to the
EcoSource+ is properly
connected.
• Ensure the Lutron
repeater and
EcoSource+ are
powered up.
*HowdoIknowwhatactionthelightsshould take?
Yourpropertypreviouslydeterminedwhichlightsshouldturnon/offforeach“scene”.Checkwithyour
property’sDOEorotherrepresentativefortheirLutronlighting“profiles”.
8) Verify the lights in the room turn on or off for this scene.
Repeat the process until all 4 scenes are successfully tested.
The 4 Lutron “scenes” are:
1. Unsold
2. Unoccupied
3. Guest re-entry scene
4. Guest first entry
7) After testing the first scene, select the next scene by
touching an arrow (up or down). The next “scene” appears on
the screen. Touch Send.
6) Verify the lights react to the scene as intended.*