Telos Vset - Assign an IP Address

Chapter 2
| 4
Installation
Assign an IP Address
NOTE: In factory default congurations, the IP addresses between a VSet and an Hx6 should default to
directly compatible settings.
Press the Menu Button and find the Setup option. Press the Line button next to Setup. This will take you to the VSet Setup
Menu.
Press the Left Line Key next to VSet IP Address and use the number keypad to enter an available IP address. When the IP
address is entered, press the line key to the left of the Vset IP Address again to save.
The Star (*) Key is used to enter a dot (.) and the Pound (#) key is used to enter a Backspace.
Then press the Left Line Key next to VSet Netmask and use the number keypad to enter the subnet mask for the network. Press
the line key to the left of the VSet Netmask again to save the subnet mask.
NOTE: Do not assign a Gateway address unless directed to do so by Telos Support.
Press the Menu Button to save settings and exit.