Chapter 2
| 6
Installation
Select Show
(Vx Only)
Since the VX Engine is a multi-studio, multi-show system, once the Studio is selected, you may need to select the Show. Press
the Menu Button to enter the Main Menu and press the left line key next to the item for Select Show. Press the left line key next
to the desired show. Once the Show is selected, the available lines will show as available on the VSet’s display(s).
After this step, your VSet is ready to control calls.
Deselect Show logs the controller out of the current show. This is necessary sometimes when performing maintenance to the
Vx System Configuration.
To Next Page
Loading...