BreezeCOMPACT System Manual
Chapter 3 - Operation and AdministrationBS Menu
Chapter 3 - Operation and Administration BS Menu
69
3.7.2.2.1.5.1 FFR Mode
The currently supported Fractional Frequency Reuse (FFR) option is None: All downlink and uplink
transmissions are with reuse 1 (full load):
» First downlink zone includes FCH and maps transmitted using reuse 1 (full load PUSC). May
include also broadcasts.
» Second downlink zone includes HARQ and Non-HARQ data traffic transmitted using reuse 1 (full
load PUSC). May include management messages.
» The uplink subframe includes a single zone transmitted using reuse 1 (full load PUSC).
3.7.2.2.2 General
The Air Frame Structure - General Tmenu enables viewing/updating the values configured for the
following parameters:
Cell ID
Preamble Group
Segment Number
Preamble Index
Total Uplink Duration
Operational Status Channel 1
Operational Status Channel 2
Operational Status Channel 3
Operational Status Channel 4
3.7.2.2.2.1 Cell ID
The Cell ID (IDCell) used for preamble selection. The range is from 0 to 31.
A change in Cell ID will take effect after next reset.
3.7.2.2.2.2 Preamble Group
The preamble group (1 or 2). A value of 2 is applicable only for the following combinations of Segment
Number and Cell ID values:
Segment Number=0, Cell ID=0, 3, 6, 9, 12, 15.
Segment Number=1, Cell ID=1, 4, 7, 10, 13, 16.
Segment Number=2, Cell ID=2, 5, 8, 11, 14, 17
The default is 1.
A change in Preamble Group will take effect after next reset.
3.7.2.2.2.3 Segment Number
The segment (BS) number in a three sector BS (0-2).
To Next Page
Loading...
