Teltonika FMC130 - PC CONNECTION (WINDOWS); MICRO-USB CONNECTION; BLUETOOTH CONNECTION; HOW TO INSTALL USB DRIVERS (WINDOWS)

Quick Manual v1.2 // FMC130
7
PC CONNECTION (WINDOWS)
HOW TO INSTALL USB DRIVERS (WINDOWS)
1. Please download COM port drivers from here
1
.
2. Extract and run TeltonikaCOMDriver.exe.
3. Click Next in driver installation window.
4. In the following window click Install button.
5. Setup will continue installing the driver and eventually the conrmation window will appear. Click Finish to complete the
setup.
1
teltonika.lt/downloads/en/FMC130/TeltonikaCOMDriver.zip
1. Power-up FMC130 with DC voltage (10 – 30 V) power supply using supplied power cable. LED’s should start blinking, see “LED
indications
1
”.
2. Connect device to computer using Micro-USB cable or Bluetooth connection:
• Using Micro-USB cable
• You will need to install USB drivers, see “How to install USB drivers (Windows)
2
”
• Using Bluetooth
• FMC130 Bluetooth is enabled by default. Turn on Bluetooth on your PC, then select Add Bluetooth or other device >
Bluetooth. Choose your device named – “FMC130_last_7_imei_digits”, without LE in the end. Enter default password 5555,
press Connect and then select Done.
3. You are now ready to use the device on your computer.
1
wiki.teltonika-gps.com/view/FMC130_LED_status
2
Page 6, "How to install USB drivers"